T Tuerca acero galvanizado M 10 x 13 x 25 mm por presas de escalada elige tamaños
You use T-nuts for the fastening of climbing holds on a wooden wall. T-nuts are the counter pieces of hexagon socket screws.
The quality of our T-nuts
Please notice that we only offer high-quality T-nuts weighing 8 g. Many other suppliers offer T-nuts weighing just 6,7 g. These T-nuts can easily turn off. Thus, pay attention to price-quality ratio!
Features:
Zinc-plated
Internal screw thread M 10
Four points support the torque.
Cylinder head screw DIN EN ISO 4762 – M10 (DIN 912)
Countersunk head screw DIN EN ISO 10642 – M10 (DIN 7991 )
T-nuts are used by furniture making, climbing wall or Boulder wall constructions, for blind and sub-constructions
Inner area
Technical Data:
Material: Steel (Zinc-plated)
Dimensions: Outside-Diameter: ca. 25 mm
Sleeve-Ø: ca. 11,3 mm
Height: ca. 12,8 mm
Edge-Height: ca. 1,5 mm
Weight: 7,8 g
Fastening:
First you have to make a raster. Therefore, mark all places where you want to assemble T-nuts. For boulder walls, a hole matrix of 10 cm is advisable (demand/qm: 95 T-nuts). The first row should be displaced to the second row.
You can also use only as many T-Nuts as climbing holds. Then you have only few opportunities to assemble your climbing holds. Furthermore, if you want to expand your climbing wall you`ll have to demount all plates.
After marking all places for your T-nuts, you have to bore 12 mm holes. Then, T-nuts must be installed in the back of your climbing wall. Use a special wood adhesive to give T-nuts a better hold.
If adhesive gets into contact with screw thread youŽll have to clean your T-nut afterward.
Las T-Tuercas se utilizan para apoyar lasestructuras en la construcción de muebles e rocódromo
Material: Acero galvanizado * cuatro puntos de apoyo el esfuerzo de torsión * zona interior
rosca interior métrica * Para una conexión segura del tornillo demadera
adecuado para: tornillo de cabeza cilíndrica DIN EN ISO 4762 – M10 (DIN 912)
adecuado para: tornillo liso fresado DIN EN ISO 10642 – M10 (DIN 7991)